Home Screen

This is your home screen for your copilot. From this page, you can choose between beginning your routes, selecting “All Clear” to ensure the bus is marked as “empty”, filling out checklists, and checking out the diagnostics of the CoPilot.

Which checklists appear on your home screen, if any, are determined by your transportation department. Commonly used checklists are pre- and post-trip checklists, as seen above.

If your home screen has a tile that says “Resume Route”, the previous driver did not select “All Clear” at the end of his or her prior route.

• Related Articles

• Copilot Startup

  Starting the copilot When the copilot is turned on, you will first see the startup screen with the Transportant logo: After a moment, the screen will inform you that routes and students are being downloaded: This screen can take about 5-10 minutes to ...

• All Clear

  When you’ve completed the route and checked the bus to ensure no students remain in the seats click “All Clear” on the CoPilot home screen to clear the bus and reset the CoPilot to it’s beginning stage. Then you can start a new route! This is ...

• Driver Clock-In and Clock-Out

  After starting the bus, while on the home screen of the CoPilot, the driver must tap their bus pass on the RFID reader (much like a student would with ridership). There are multiple ways to confirm the driver’s swipe was accepted: A small black box ...

• Lost Connection Notification

  When the copilot is unable to get a GPS signal after one minute, the message “Connection lost. Trying to reconnect…” will be shown on the copilot screen as seen below.

• Diagnostics

  The Diagnostics tile gives a quick overview of the Bus Number, Attendant Number, CoPilot Number, and Connection Information. These are the devices that the CoPilot is physically connected to. Note: If the Attendant and CoPilot numbers do not match ...