Driver Clock-In and Clock-Out

After starting the bus, while on the home screen of the CoPilot, the driver must tap their bus pass on the RFID reader (much like a student would with ridership). There are multiple ways to confirm the driver’s swipe was accepted:

1. A small black box will pop up with the driver’s name in the bottom right corner with a verification that the driver has been clocked in.
   
2. The driver’s name will show up in the upper right hand corner of the CoPilot, next to the bus name.
   
3. The driver’s name will show up under the diagnostics tile of the CoPilot
   

Drivers must clock out at the end of their route by tapping their bus pass on the RFID reader. Once clocked out, the driver's name will no longer appear as described above.

• Related Articles

• Home Screen

  This is your home screen for your copilot. From this page, you can choose between beginning your routes, selecting “All Clear” to ensure the bus is marked as “empty”, filling out checklists, and checking out the diagnostics of the CoPilot. Which ...

• Ridership Tracking at Stops

  Ridership Tracking Basics Once the Stops screen pops up, students can be tapped on and off the bus. How this is done is up to your school district. Many districts have students scan on with a bus pass. This can be an RFID card or fob, or a card or ...